|
|
10-19-2011
I'm getting ready to install subs and a mono amp so I'm trying to get as much info as i can before i start this project. I trying to figure out what is the best way to run the amps power wire from the battery to the trunk where the amp is. Is there a hole in the firewall that is big enough to fit 4g wire?
10-19-2011
If you pull back the passengerside carpet. There's the wiring grommet down there. It pops out by the ps rack on the passenger side.
That's where I put my 4ga through.
10-19-2011
Good idea i forgot about those. How did u seal it up after u ran the wire
10-19-2011
I punctured it undersized. Ran my wire puller (old shifter cable) in from under the car and pulled the cable out from the interior. It's so tight..it's self sealing.
10-19-2011
I ran mine in the same spot. It sealed itself... or you could hippy rig it and put it over your fender/through door. ive seen that and just laughed
10-19-2011
Bill - Thanks for the info. sounds a lot easyer than i thought it would be
10-19-2011
NewBoost - Trying to keep it looking clean so wont be doing that lol
10-19-2011
I ran FOUR 0 gauge through that hole! 2 runs of ZERO gauge for the positive and 2 runs of ZERO gauge for the negitive...
10-19-2011
^Dam dude that must be one serous system u have
10-19-2011
Check out the youtube, I gotta put up a new vid, but you get the idea...
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
