Thread: Crimping Large Wires

1st
I would get a pole mount connection.

2nd if that is not an option. Pair of dykes

if you know any electricians they might have access to a larger crimper for something you need crimped or before you install the wiring take the cable and connectors to a shop and they would prob. do it for nothing.
idk....call around to some different electrical shops and see what they say.
You don't want to buy the tool for a couple of crimps unless you are going to do a sh*tload of crimps.
We crimp ground lugs on #6 ground wire all the time and you would need a crimp tool at least that big and that crimper is the same size as large bolt cutters.

I always crimp my connections and then solder them as well. If you don't have a big enough crimping tool

You can take a metal punch and hammer the punch into the metal connector (once wire is inserted into connector) which will put a dimple in the metal which will preven the wire from sliding out. Then you can use a blow torch (mini or big one) and heat the connection up and then insert solder into the connector. The solder will want to flow to the end of the wire because of the capillary action going on.

When we built my dads plane, we rented a electrical crimper that could crimp huge wires. Then every crimped connection was soldered which will cut down on resistance as well as offer a security net from the connection from ever breaking loose.

Originally Posted by JJ91284

I always crimp my connections and then solder them as well. If you don't have a big enough crimping tool

You can take a metal punch and hammer the punch into the metal connector (once wire is inserted into connector) which will put a dimple in the metal which will preven the wire from sliding out. Then you can use a blow torch (mini or big one) and heat the connection up and then insert solder into the connector. The solder will want to flow to the end of the wire because of the capillary action going on.

When we built my dads plane, we rented a electrical crimper that could crimp huge wires. Then every crimped connection was soldered which will cut down on resistance as well as offer a security net from the connection from ever breaking loose.

That would work, since we are not dealing with a high voltage here, 14.5-14.8 at the very highest normally.
In electrical applications soldering connectors is unacceptable......in this application there should be no problem.
I wouldn't want you to burn your house down due to a electrical fire.

Originally Posted by dstout

That would work, since we are not dealing with a high voltage here, 14.5-14.8 at the very highest normally.
In electrical applications soldering connectors is unacceptable......in this application there should be no problem.
I wouldn't want you to burn your house down due to a electrical fire.

yeah I knew that, aviation and automobiles use low voltage systems so thats why I recommended it. I know my dad re-wired his sailboat and we did the same thing since the boat is on 24 volts