|
|
09-16-2014
So after my rebuild I decided to run my stock pulley for the first few hundred miles and also while dialing in the tune.
My question is then when I swap my 3.4 back on now that I added the VS cam should I run AL 104's? What would you all recommend?
Thx
09-16-2014
I would. I have a Comp Cams camshaft, similar to XP and I run 104's on my 3.4
It was recommended that I do that by everyone I talked to
09-16-2014
I couldn't remember if I go 605 or 104. I think I go 104 until I drop below a 3.2 right?
09-16-2014
104s are what I run
09-16-2014
Yeah, I think rule of thumb for most people and most applications it's smaller than 3.2 you go to 103's
09-16-2014
I run 104's
09-16-2014
103's are almost never needed.
104's will work for just about every car.
Or why not do real world testing, which nobody ever does. Buy both sets, installed them and do some pulls and pull all plugs back out. Read the plugs and see what ones are best for you.
09-16-2014
I think he was asking 104's or 605's for his mod level.
09-16-2014
Yeppers^^^
09-17-2014
Definitely 104s
09-17-2014
I'd run 605
09-17-2014
Thx 4 the post all.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
