Thread: What would i have to do to safely run a 3.0 inch pulley?

I didn't mean to sound mad, or like a dick...
I'm hoping you've clicked it by now, so this NEVER HAPPENS AGAIN!

j/k

Originally Posted by FastKatt

I didn't mean to sound mad, or like a dick...
I'm hoping you've clicked it by now, so this NEVER HAPPENS AGAIN!

j/k

No worries...... This is what I saw that made me say what I said.....

Originally Posted by FastKatt

I have a MPS from ZZP (3.4 & 3.2)
On Slicks, last fall I ran a 13.274 1/4m with the 3.2 pulley and STOCK Timing...
No Cam, No Rockers, No IC!

I believe with the tuning I've done since, I should be in the high 12s with the same mods
HTH

Hence my suggestions. I'll be sure to CLICK next time

Originally Posted by silverbullet

i'm running 3.1 right now just to be on the safe side until it warmer so i can have trannyman retuning it. hopefully i get full size ic before then so i can drop down to 2.9 pulley. my mods: xp, pp heads with L32 valves, 3.29 gear, zzp input, N* tb, ported inlet/outlet blower, ported lim, 42.5 injectors, cai, pacesetters, and 3" exhaust.

The heads make a lot of difference in what size pulley you can run. I have basically the same set up as you but w/o the P&P heads and I can only go 3.25 on the pulley.

Goal - WOT 17 - 18* timing, 11.6 AFR and NO KR with my mods = 3.25

Originally Posted by IndeedSS

Goal - WOT 17 - 18* timing, 11.6 AFR and NO KR with my mods

DING DING DING

get the car running right, then choose the pulley according to this