I located an l26 for my 99 GTP. For this swap is there anything else i will need to swap over besides l67 heads/valve covers/LIM/flywheel/crank pully/supercharger/fuel rails/oil pan/windage tray. Can i leave the lifters in the l26 block and run the pushrods and rockers from the l26 in the l67 heads? I will be running an S1x with this engine.
EDIT---I have a set of bare l67 heads at home. I have read about some machining a certain amount off but i am unsure what i should do. Anyone point me i nthe right direction? Also if this is done would i have to get different length push rods? Or anything else? The same goes for the head gasket. Unsure what thickness would be good. This will be my DD
