|
|
10-24-2008
Every time i take my car for a drive, by the time i'm on the highway which is about 5 minutes away, my cruise control doesn't work.
The little plastic piece on the end of the cable keeps coming off of the throttle lever. Is there a way to shorten the cable/tighten the plastic clip?
10-24-2008
Make sure you're snapping it on all the way. Mine seats with a very confident "snap" and requires a lot of effort to get back off again.
10-24-2008
Hmmm. That may be the problem. I have just been sliding it over the little knob, never bothering to push the knob further into it.
Just went out and reattached. Didnt hear a click no matter how hard i pulled.
Then i tilted the clip towards the engine and pulled, and sure enough, a nice reassuring click. We'll see if it stays put. Seemed sturdy
Another big thanks to Sabre! :P
10-24-2008
If it actually snapped, then you should be good to go. I can understand why it was coming off if you stopped just shy of snapping it.
Let us know how it goes.
10-24-2008
"Gorilla Glue"
10-27-2008
I'm not kidding here when I say this....I had to put a little silicone adhesive in the connector and then put it on the throttle body. I've had mine off so much that it pretty much wore the plastic connector out. Don't use a whole lot, just enough to keep it there.
10-28-2008
It has stayed put for 3 days now so i think we are in business.
If it starts being troublesome again, a little adhesive wont hurt
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
