Got my generic HeliCoil kit today. Surprisingly fast considering it came all the way from the U.K.
And it's the correct one!
Looks like I will not be needing to pre-drill
Hole before tap
And after
HeliCoil in. She's a bit long.
Instructions say to "break off the tang." Not sure that's going to cut it.
A little Dremel action to cut through one of the coils
Plug goes in without any issues
There's even enough leftover in this coil to do another pan
Magnet layout
This should be good to hold them
And they're in
Going to let it cure overnight, then toss the pan on tomorrow