JB Weld brotha!

They used clear resin epoxy which wouldn't even hold paper together. No wonder it failed on them. I was able to remove all their glue with a razor blade very easily. I notched the I.D. of the tank and the O.D. of the billet bosses so when it was installed the JB Weld would have something to grip to and not allow the bosses to spin when you were screwing in or out the fittings. Thats what I think they did was tighten or loosen a fitting and it broke the glue and make it leak. I added those drill index holes on each boss so I could hold the boss with some snap ring pliers while I tighten or unscrew the fittings, but so far, the JB Weld is holding strong enough, I haven't needed to hold them.

Them suckers are on there good now.

~F~