Originally Posted by Dohner
there is an inline connector in the passenger rear of the trunk that connects the harness to both tail lights/turn signals etc. these connectors are readily available from an electronics part supplier. if you were to get the connectors, and the resistor modules, you could then make up a short extension harness that had the resistors wired into it, (should mount them in a small aluminum box to help with heat dissipation) so then you would just unplug the factory connector, insert the new extension inbetween, and your LED's would be good to go... then if you remove the led's then you just unplug your short extension harness and plug the factory harness back together.
i havent written up the whoe thing yet, but the parts are readily available, and i can put those together if needed.
