now how do i go about doing that to an l26 LIM. it doesnt have a deep wall. its just an edge really. I thought about jb weld but i dont know how i would get it from sinking.
also can i reuse the stock gasket frame when i put the hv3 in ?
|
|
06-15-2011
now how do i go about doing that to an l26 LIM. it doesnt have a deep wall. its just an edge really. I thought about jb weld but i dont know how i would get it from sinking.
also can i reuse the stock gasket frame when i put the hv3 in ?
06-16-2011
Drill and tap the same way I show in the pictures. The thickness of the manifolds are all nearly the same. Go slow on tapping and checking to see when the plug is nearly tight. That way you can control that the head of it sits flush.
I don't know if you can reuse the gasket. Can't tell from here if your gasket is still good or not. If you are not sure, replace it for the peace of mind.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
