Now for the orange constant battery power or memory...there was a plug that had wires taped with the harness under the dash with an orange wire that had constant battery power or (memory). I just spliced into it for the orange wire.
If you can't locate the little plug with the wires you could use the constant power from the cigarette lighter or create your own by tapping into the constant power for the radio memory or running a wire to the fuse box.


For the tan wire on your digital dic harness.... you need cut a nice length of wire (I used like 2 feet ,don't worry you can always shorten it)to splice into the tan wire that is on the diagnostic plug( OB2 Port) Run the wire up behind the dash and to the harness . I did not cut the wire but used a splice connector for the end on the OB2 port and simply crimped the wire on the digital dic harness end.

The dark green wire for the vss (vehicle speed sensor) you need to splice into the dark green wire on the back of the speedo. There are a few of them. The wire is the second in next to a grayish brown wire.

(Note this is for 97 only: ) What I did for my (vss wire)I cut off one of the old pins from the old connector/plug from the analog dic( make sure you leave plenty of wire to splice into. I used about a foot or so of green wire I picked up at the store and crimped one end to the PIN), you'll simply slide it (the pin you just crimped the wire to) back into place on your instrument cluster connector in location C1-F. Then run the wire through your dash over to the digital dic harness. Crimp the end of the wire you just ran from your instrument cluster to the (purple with white stripe wire) marked B-10 on the connector/plug from your digital dic harness.

I didn't use the gray/black vf park wire at all.

Once you've got all your connections made and everything is plugged back in.....Turn your key on, your DIC should light up , start your car and you can test everything out by opening your doors to see if the door indicators blink and the chime makes noise. Same with your trunk , pop it open you'll see the icon for the trunk flash and hear the chime.

You can then (page) through your DIC info by pressing the mode button. You should see a percentage of your oil (example 100 percent) means the oil has just been changed) For my car in particular it was 65 percent which means the oil was through 35 percent of its life. Don't worry though, your oil percentage will read different than everyone Else's

You can also view your average MPG , Range (approximate mileage til you need to put fuel in),Fuel used (example 2.4 Gallons)

The dic will also flash a washer fluid icon over the engine area outline of the car when its low.

Low fuel warning also happens. If you have 60 miles or less to go on a tank of gas the DIC will flash LOW and the chime will start chiming

I hope this helps you guys out some.