11.5 is fine. Shoot for the same afr using nitrous as you would without.Originally Posted by suitercrew
I would go with a wet shot. Most solenoids will support 150 shot if you want to turn it up more. And, you will.
|
|
10-01-2017
11.5 is fine. Shoot for the same afr using nitrous as you would without.
I would go with a wet shot. Most solenoids will support 150 shot if you want to turn it up more. And, you will.
10-01-2017
even if you are running E85?
10-01-2017
I don't have my wideband changed to e85 because regular gas is easier for me to understand but it all comes out the same
Sent from my LG-H918 using Tapatalk
10-01-2017
it's still the same
10-01-2017
Hey question why does it seems everyone else run like 12-12.5 afr boosted or n/a but everything I have read is mid 11s afr unless your turbo and then low 12s afr?
Sent from my LG-H918 using Tapatalk
10-01-2017
I don't know where you found that. But most cars na will run mid to upper 12's. Boosted will be somewhere in the 11's.
You can lean it out more, but you need to spend a few grand on sensors so you know what's going on.
10-01-2017
Hmm ok. Thanks for clearing that up for me.
Sent from my LG-H918 using Tapatalk
10-01-2017
Who's "everyone" else? What type of boost, what compression ratio are they running? Too vague...
GTPpower said it all!
10-01-2017
I usually target 11.5 on my grand prix
10-02-2017
Hey does anyone know if you can run a wet kit as a dry kit? I found a really good deal locally for a wet kit. I figure you could just not hook up the fuel solenoid right?
Sent from my LG-H918 using Tapatalk
10-02-2017
I would go for it. I bet the ethanol and gasoline running through the blower would work even better as an intercooler than just nitrous running through it.
10-02-2017
and a larger fuel pump. the pump you might have now for e85 wont be enough.
10-02-2017
Ive heard that gas is bad for the rotors.
Sent from my LG-H918 using Tapatalk
10-02-2017
I have a 320lph aem pump with a caspers rewire so I think ill be ok.
Sent from my LG-H918 using Tapatalk
10-02-2017
its been done before and works fine.
10-02-2017
I've heard that it's just fine. and even if it is, who cares? it's a gen 3 blower, will last plenty long enough and when the rotor coating is gone, another blower is cheap.
10-02-2017
maybe not. guy in NC was running it and would run lean, iirc he had to get a 500 something, said when it turned on you felt it though the whole car, he was also on e85.
he was also running like 22º wot gen 5, 2.6 and no kr. he was blowing the doors of ls cars with bolt on mods daily lol
10-02-2017
I also worry about the fuel solenoids failing and being screwed. It honestly just seems a lot safer to have a dry system that you can just swap pcms/tune. Either way maybe ill try it if this guy ever messages me back now.
Sent from my LG-H918 using Tapatalk
10-02-2017
Well I definitely plan on starting with the smallest jet first and work my way up so ill keep an eye on the wideband. But that guy was also probably making at least 50 more hp then I am and was probably doing bigger then a 50-75 shot.
Sent from my LG-H918 using Tapatalk
10-02-2017
he started at 50 stopped at 150 lol went back to a 75, still needed the larger pump no matter that jet he used.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
