Some more top swap questions! Yay!

[Tonkin2000GT]

Most auto parts stores don't even have impacts let alone rent them

Sent from my SM-G920V using Tapatalk

[Tonkin2000GT]

If you know anyone with a shop or something I used a cordless snap on impact

Sent from my SM-G920V using Tapatalk

[suitercrew]

Ok ill check the rental in the morning or just see if my dad can bring his over tomorow. Now the map sensor wires are they excactly the same for the l67 map sensor

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

I'm not sure on that I'm using my L36 map sensor

Sent from my SM-G920V using Tapatalk

[Scottydoggs]

if they are the same colors match em up. if not the same colors one wire might have a line on it, match the two with lines together.

just twist and tape the wires till you know its working right, aka not setting a code. if all goes well solder them in.

[Tonkin2000GT]

Lol yea and a couple map sensors later.....

Sent from my SM-G920V using Tapatalk

[suitercrew]

Doesnt a black line usually mean its a ground?

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

It all depends how about some pictures of both sets of wires?

Sent from my SM-G920V using Tapatalk

[suitercrew]

Old plug

Sent from my LG-D851 using Tapatalk

[suitercrew]

New plug

Sent from my LG-D851 using Tapatalk

[Scottydoggs]

see the a b c on the plugs, id try to match that up.

[suitercrew]

Ok well see haha

Sent from my LG-D851 using Tapatalk

[suitercrew]

What goes in between the coil pack bracket and the tensioner is there a bolt or what. I cant get the tensioner to sit right

Sent from my LG-D851 using Tapatalk

[Scottydoggs]

the long stud goes through the large hole on the coil bracket, then line up the bolt holes.

zoom in on this pic,



on the inside of the bracket is a 1/2 circle, the icm harness goes in there, watch you dont pinch the harness when bolting it down.

[suitercrew]

Ya but does anything go on the stud right after the coil bracket and before the tensioner. I put bracket on then very next thing was the tensioner and it just kind of sits funny

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Nothing goes on in between the braket and tensioner there's a little nipple on the back side of the tension that sides face you on top of the braket so it doesn't spin you probably just have to rotate it a litlle

Sent from my SM-G920V using Tapatalk

[Tonkin2000GT]

Sent from my SM-G920V using Tapatalk

[suitercrew]

So this is good?

Sent from my LG-D851 using Tapatalk

[suitercrew]

Sent from my LG-D851 using Tapatalk

[Tonkin2000GT]

Looks good!

Sent from my SM-G920V using Tapatalk