Custom Poly Trans mounts done Updated 3/7/13

[91parkave]

The mount I used was a GTP mount the dimensions for the poly block anyway. Also the Gxp and GTP trans mounts are the same the bracket is just cast aluminum nd thicker but no change.

[Damnir]

The mount I used was a GTP mount the dimensions for the poly block anyway. Also the Gxp and GTP trans mounts are the same the bracket is just cast aluminum nd thicker but no change.

Right on, that's good to know! Are you keeping the mount as-is, or are you going to make further changes to it? Possible to put up your spec sheet on it? ie; hole locations from left/right, top/bottom, etc? I was trying to make sense of the picture you uploaded, but the resolution isn't good enough to make it out!

Since I work in the truck/car industry, I have a lot of hardware laying around. I am sure I could find proper sleeves and corresponding threaded rod to make them more "oem" like.

Thanks