Anyone know if there is a module that can be wired in to bypass the pk3 theft system for a 2004gtp ?
|
Anyone know if there is a module that can be wired in to bypass the pk3 theft system for a 2004gtp ?
You can bypass the passlock with a correct resistance resistor in place of the key cylinder. Cut signal wire that comes out of the passlock (should be orange) and test with a dmm on the key side while cranking. (have car in R or D to prevent cranking with brake on, wheels chocked) The resistance value you test here is the resistor you must buy. Solder in the resistor between the car side of the wire you cut and the passlock ground wire. I have done this on a couple of car's when doing aftermarket remote Start's before they had all of the bypass module's.
You can also add the alarm/remote start bypass and use a relay to convert polarity to activate the bypass with your ignition 12v feed. All these modules do is duplicate the resistance value and uses a relay to activate.
Sent from my XT1080 using Tapatalk
Last edited by osiris94ej; 12-24-2013 at 02:30 PM.
Not sure what you're asking, or want to accomplish.
But there's a programming sequence to relearn the key if that is what you're asking.
Search, it's out there and simple to do.
The key is the resistor?
I have more than 10 years experience installing car electronics. I have bypassed more than one using this method.
http://vatspasslockpasskeysecurityhelp.yolasite.com
Sent from my XT1080 using Tapatalk
Last edited by osiris94ej; 12-25-2013 at 11:53 AM.
Thanks for the info Osiris the newrockies type bypass is exactly what I need except it onley works for the 94-03 mine is an 04. I will contact them to see if they have updated.
« Previous Thread | Next Thread » |