Thanks again guys.
The paint used on the blower housing is VHT high temp wrinkle finish. It came out pretty decent, very dissappointed in the dry time though as it was still soft after a full week! It was even sitting under a ceiling fan that I leaving running 24/7 and the furnace blows straight into that area, so to anyone who wants to use this paint I hope you dont plan to handle the parts for a while. I used a different wrinkle paint on some other parts a few years ago and acted about the same way, its just the nature of the paint and thick heavy coats required to get the look.
Nick- I fixed the frame on my cutlass summer 09 so its good now. The front/top of the rear lower control arms section of the frame ripped off the control arm bracket from hard launches. I thought it was only the drivers side but ended up being both sides. Luckily there is a body seem directly above this under the rear seat so it was half easy to get in and do it, just had to cut the floor a bit and fold a section out of the way to get in and clean the metal and weld it back up. The factory welds were not very stout so it was welded up much better than factory and reinforcment plates were welded in so it shouldnt happen again.