Getting ready to put in the aeroforce
Finally showed up
Almost ready to install
Insulating the gauge
All done
All cleaned up
|
I always keep wanting to go back to the vent set up instead of a pillar.. I might just need too.
Rims look good as is.. I think if you lower it it'll look 1000x better. I think a nice gunmetal could look good.
Where's you get the piece to fill the gap in the vent for the aeroforce if that makes any sense.
Staples .. its a 60mm wire grommet then I took a file and filed the edges down a bit so it would fit in the vent. Then I cut out grooves so the factory silver ring would fit in place tried to keep it legit and stock looking
Sweet. I'll keep that in mind if I happened to go back to it.. I don't remember what I needed up using but that's was years ago.
Finally got my HIDS PUT IN heres some photos
Got these for 50% off on BF from ZZP 6k 880's
Really nice for 34 bucks
Really solid ballast
Comparison
Rigged up with zip ties no where else to put it
All Done
![]()
Did you notice much difference at night with your fogs?
« Previous Thread | Next Thread » |