Wires nave have came loose on the coil. Does the cone still move freely if lightly pushed on?
Sent from Not so smart smartphone
|
|
02-26-2014
Wires nave have came loose on the coil. Does the cone still move freely if lightly pushed on?
Sent from Not so smart smartphone
02-26-2014
yes it does, is there a way to fix this if it is the problem
02-26-2014
it has a slight resistance in the motor/cone
03-11-2014
Yea its possible to fix it. But its delicate work depending on Where its broken.
It shouldn't have much resistance out of the box, but it will have a very slight amount. If it sounds like the cone is dragging then you have other issues.
Sent from Not so smart smartphone
03-12-2014
I'm not sure if I can fix them. I have the equipment but I've never repaired this kind of speaker. I might check it out tonight depending on how bored I am.
07-29-2014
Got the 3.5 put on finally. I defiantly enjoy it. Needs more suspension upgrades, sway bar and whatnot. With how slow I modi probably buy the parts in October and wait until February to put them on.. Lol
09-05-2014
Got the wheels put on but I have a hellatious vibration after letting off the gas at 50mph. Any ideas the cause? Maybe a bent wheel? I have all new tie rods inner and outer. Rack is tight... Oh an I can't take them off because the dumbass who mounted the tires used a impact with no torque stick on the wheel locks.
09-22-2014
Fvck the wheels. It looked good but rode like sh%t. Installed some a-pillar tweeters. Sounds better. Pulled them from a gtx clone at the local pull a part. Found a mps hub but didn't have a puller... Oh well
10-21-2014
10-21-2014
Cool pic I took around the corner from the house
10-23-2014
Lookin Good, nice pic.
10-25-2014
did u ever figure out your vibration? my idea of why ur car vibrates is ur wheel balancing is alighlty off it happen all the time at my work sometimes wheel weight fall off soo it could be that if not jack up ur car mover your wheel very slightly right to left there should be no play and north to south also there should be play but even that wouldnth make your car vibrate
10-26-2014
It was the wheels, I replaced the tie rods and didn't fix it so I pulled them off
11-19-2014
HavingHaving fun with this whole winter thing this year, getting up to 12.6lbs o'boost with just a 3.5 pulley. Looking into getting some projector lights. Any suggestions on amazon/eBay. I know classy and another fella are making them but the smoked quad projectors look slick.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
