Alright so good news n a little bad! I got both projectors aimed n mounted! Bad is one of my ballasts are bad so what sucks is I couldn't have them both aimed at the same time to line them up flawlessly, but I used tape so they should be close, at least I'm hoping/praying lol. They weren't too too hard, and if I would have had both ballasts working, I think I could've gotten em pretty damn close to perfect. The jb weld trick holds pretty good. I'd aim them, throw some on one side n the bottom n hold till it hardened n would get them exactly to where I wanted them. Then do the other side n top in front. Let them harden, n then take them out n seal in the back, so they shouldn't go anywhere! From what I understand I may still be able to adjust a tiny bit so well see. So I also did my other side fender stripe n came out pretty good! I ordered some drilled n slotted rotors and some new pads for the front and rear and I'm going to repaint my calipers a metallic red to help em pop more! Also gonna try n either do a red bracket n gunmetal caliper or vise versa depending on how it looks, I think that'd look pretty sweet tho. Anyways, PICTURE TIME! Also any tips from where to get a new ballast? Ddm maybe or what?
Helpful way to get it like the other side, measure from the bumper to bottom of fender and tip of fender near headlight to fender stripe.


Rubber butyl first to help hold before jb weld


Work station

My Jerry rigged wall since I have a damn bush in front of house and was planning on doing them at the same time until I found out the right ballast was bad.

dryed jb weld, gonna have to paint a little silver, it barely shows on side of shrouds but just to clean it up a little and hide it

n then sealed in the back

idk why ima show y'all but a sneak peak of what they'll be!!

can see some jb on the side but got the clears in, will need to silicone them still.