Schwing!
Printable View
Schwing!
It's a shame that those super awesome valve covers will be covered by the coil bracket...
Quote:
Originally Posted by Sandman
not all of it will be covered.
wow that's an awesome build and a very nice GP, what heads are they?
Anyone care to explain how the Cam Crankshaft Sensor works with the Balance shaft deleted and with the XPZ Cam?
ZZP Aluminum heads with 150# springsQuote:
Originally Posted by gtpeddie
wow that's a hell of a build! i cant wait to see how this comes out i never seen anyone on here with aluminum heads, but i only been on here since January
ZZP made 100 Sets of them. Then discontinued them. They retailed for about $2100 alone. and if i recall correctly the final set of them sold on Blackfriday 2011 for upwards of $4800 ishQuote:
Originally Posted by gtpeddie
yea i knew they were expensive, you have a rare set your lucky and you will have one fast GP!
That would be awesome, at the rate my coupes getting done I'll be drawing a pension by the time its done.... FML I could always drive the ugly 4 GT twin down but its piss slow.Quote:
Originally Posted by Spartan GL
Any track dyno sessions comming up?
We have a local drag stip that does a monthly street heat and there is a Dyno over here in Tampa that is quite nice
Sold my Engine Stand and Engine Hoist today for $200 :) successful day
Ugh, I wish I had time, money and a spare car so I can f*ck with my GT's motor.
Thats why i bought the new Civic Hybrid. So i can drive and play at the same timeQuote:
Originally Posted by LowRidinCrew
http://i917.photobucket.com/albums/a...l/25954325.jpg
For those who missed the Mockup photo :)
bet you can wait till thats in your car lol
working on it currently!Quote:
Originally Posted by gtpeddie
Stop mocking and start working.
My suggestion based on the mods I see.
Bolt on the water pump
Oil pressure adapter (spring into cup then spring into timing cover) then adapter.
Put an old filter on it for the install. You don't want to take the chance of dinging the end of the adapter.
Put in the oil level sensor
Put pigtail on the rear knock sensor
Put lim on and nothing else on the top
Slide rear header into tunnel before dropping motor/trans into place.
And if you haven't already..pressure wash your engine bay
Enjoy..it looks pretty.
is the pulley all the way on the blower?
I will be cleaning the engine bay up today.Quote:
Originally Posted by BillBoost37
We already put the waterpump and oil reg on.
In that photo it wasn't. Now it is on all the wayQuote:
Originally Posted by redlinepontiac