Will these tips fit 😆

[Jnibbs24]

http://m.ebay.com/itm/2X-Exhaust-Dua...859?nav=SEARCH


They've been jumping around from 80-92$ will they just slide over the stock exhaust?
97-03.
Thanks

[Bio248]

stock pipes in the rear are 2.25". you'll need a pipe expander and a welder.

[Fivefingerdeathpunch]

Hold up there brotatoe chip, stock exhaust after the "Y" is only 1 7/8th. Either way you'll need an adapter/pipe expander and a welder.

[stealthee]

I just went out and measured mine. From the muffler exit to the pig snouts is 2.25 OD.

[Fivefingerdeathpunch]

I believe the 97-03 is different.

[stealthee]

That's a possibility. The Pig snout is also 8.5" long measured from the top of the snout to the back of it where it is welded to the muffler exit. One would probably want at least a 9.5" OL tip in that case.

[stealthee]

I would go with something like this

http://www.ebay.com/itm/Muffler-Tip-...dd09dc&vxp=mtr

I'm thinking about ordering them myself since I need a little exhaust work done anyway. The dual 3.5" tips look like they will be a tight fit, but should work, unless someone else has knowledge otherwise.

[Bronco Boy]

The output on my stock mufflers was 2.25".

[Jnibbs24]

Yuck, those do look like 28$ tips... So either way the tips will have to be welded on?

[stealthee]

You could clamp them, but I wouldn't do it that way myself.

There is also these ones, but I don't think 9" OAL is long enough.

http://www.ebay.com/itm/Pair-2-25-An...e4aa0d&vxp=mtr

Thinking about it again you probably want at least 10" OAL, or you would end up tucking the tips under the bumper further.

[Bio248]

so what is it, 2.25" or 1.875"?

[Bronco Boy]

http://chrisb.users.superford.org/Gr...aust_Tips.html