Oh well In that case lol. Well do you have someone to install the trans? Installing the PCM is extremely easy and doesn't cost a dime. Just trying to find you the cheapest route possible.Originally Posted by drain bamaged
|
|
03-28-2012
Oh well In that case lol. Well do you have someone to install the trans? Installing the PCM is extremely easy and doesn't cost a dime. Just trying to find you the cheapest route possible.
03-28-2012
you can get a mail order tune cheaper then that
03-28-2012
I stand corrected lol. Cheaper
03-28-2012
ZZPerformance - ZZP 1.0 PCM #ZZ-10PCM
W Body Store
ok maybe not that much cheaper but close and you dont have to worry about a trans install
03-28-2012
so which should i do im not worried about the install i just whats best is the trans really stronger i relize a lower gear is a little faster off the line but what do you recommend i do
03-28-2012
Tuned PCM. Save monies for mods
03-28-2012
the transmission is 150 and a tune is over 200
03-28-2012
If I were you I'd buy both, I'd buy that cheap trans and save it to slowly do a trans build and get a tuned pcm from zap just to get the car moving again
03-28-2012
well ill go for the trans and save my monie for the pcm as i plan on mods any way that why it can go in for it at once will the vin not matching matter much just wish i could drive it with out doing the both or at least one
03-28-2012
Yes, buy the tranny. You will be super pissed when you case the tranny after beating on it for a few months. Then be like, "why did I pay for that tune and still end up with a f**ked tranny, why didnt I just pay less for the HD tranny to begin with?"
08-19-2012
well the car is dead the bottom fried a bearing still ave to pull it to find the knocking
08-19-2012
Replacing it? Ever get your trans figured out?
08-23-2012
i bought te hd and had the pcm flashed for it. i was driving it for two weeks then it started knocking
08-23-2012
Throwing a motor in it?
08-25-2012
Welcome!
09-21-2012
well looking for a new crank spun all six rod bearings and one main
09-21-2012
id look for a new to you used engine.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
