Thread: How to fix Regal dim HVAC

Results 1 to 9 of 9
  1. #1 How to fix Regal dim HVAC 
    Turbo is the way to go. BillBoost37's Avatar
    Join Date
    Jul 2009
    Location
    W Spfld
    Posts
    26,833
    Thanks (Received)
    53
    Likes (Received)
    90
    Dislikes (Received)
    1
    Most HVAC control units suffer a dim or not visible display. This problem is caused by some surface mount resistors in the back of the unit. A few minutes with a soldering iron and this can be fixed for free.
    Open the center console and remove all the stuff in it.
    Remove the rubber piece at the bottom of it and you will see two 10mm bolts, remove them
    Lift up on the trim panel that sits between the cubby hole door and the console door. Unhook the traction control (and heated seat) connectors and set the piece aside. Looking in you will see an inline connector (white IIRC) disconnect it. That's the power and such for the center console.
    Looking straight down behind the shifter are two more 10mm bolts, remove them.
    Looking in at where the dash meets the lower dash, you will see a 10mm bolt on each side. Remove both of them.(looking straight at side of console from driver or passenger door.)
    Now the tough part. The passenger side of the console contains a cigarette lighter socket. The FSM says to use special J tool to try and get it out, then when you break it to replace with part XXXXXXX. The socket hits on the shifter assembly as you pull the console back. I find that two small screwdrivers can sometimes do the trick. BTW it still has pwoer, be careful putting metal into it. Expect that the socket will get bent and won't work properly afterwards or slide the console back as far as the socket allows and work your way in with the 7mm driver to get the four screws holding the HVAC to the dash. Then pull the HVAC up and out and disconnect the connector for the wiring.
    Here is the backside of the HVAC unit. Remove the four screws.

    Leaving the unit face down lift the back off the face. The face contains many buttons and parts that will fall on the floor if you seperate it or invert the face while it is off the back.
    Looking at the back now, remove these four screws.

    Wiggle the back circuit board out of the plastic housing. Set it down with the pins facing up.

    These five surface mounted resistors are the issue. They need to have the solder reheated to reflow it.

    This is done by touching a soldering iron to the metal ends of the resistors

    Reassemble the unit and go try it out. It should work again.
    I drink..so consider that when reading my posts.

    2010 Audi A6 Dual IC's
    Reply With Quote  
     

  2. #2 Re: How to fix Regal dim HVAC 
    GTP Level Member chevyy1212's Avatar
    Join Date
    Oct 2008
    Location
    IL
    Posts
    974
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Wheres these 2 bolts were the dash meets the lowers dash? Way lost on findin those
    1998 GS with Open cone, PLOG, ZZP Catless DP, tune & Intense MPS 3.6. Pulls good enough to make the woman smack me and call me a D!*k.
    Reply With Quote  
     

  3. #3 Re: How to fix Regal dim HVAC 
    GTP Level Member chevyy1212's Avatar
    Join Date
    Oct 2008
    Location
    IL
    Posts
    974
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Scratch that I spent a hour being an idiot found it. Now for this stupid cigarette lighter... SUCKS
    1998 GS with Open cone, PLOG, ZZP Catless DP, tune & Intense MPS 3.6. Pulls good enough to make the woman smack me and call me a D!*k.
    Reply With Quote  
     

  4. #4 Re: How to fix Regal dim HVAC 
    Turbo is the way to go. BillBoost37's Avatar
    Join Date
    Jul 2009
    Location
    W Spfld
    Posts
    26,833
    Thanks (Received)
    53
    Likes (Received)
    90
    Dislikes (Received)
    1
    FWIW the cig lighter says in teh GM manual to try X tool that pulls the two tabs in..if that doesn't work, break it and charge customer for a new one.
    I drink..so consider that when reading my posts.

    2010 Audi A6 Dual IC's
    Reply With Quote  
     

  5. #5 Re: How to fix Regal dim HVAC 
    Killa Bee Scottydoggs's Avatar
    Join Date
    Aug 2010
    Location
    new jersey
    Posts
    39,997
    Thanks (Received)
    63
    Likes (Received)
    166
    Dislikes (Received)
    5
    Quote Originally Posted by chevyy1212 View Post
    Scratch that I spent a hour being an idiot found it. Now for this stupid cigarette lighter... SUCKS

    the power ports should stay in their mounts in the console, you un hook the wires, and leave it all in place. i un hooked the heated seat, and trac off buttons from under the cup holder. and that's it.

    if you leave the 2 pita bolts off the back corners where the console bolts to the lower dash trim, (where the climate control trim is) it all comes back apart later much easier if you ever need to get in there again.

    98 Buick Regal GS, F body brakes, Caddy STS wheels, tinted tails L36 bottom end, lightly ported heads, 1.95 roller rockers, headers, gen 5 N* 3.0 pulley, FSIC, 42 lb injectors, a BrandonHall rebuilt trans, DHP tuned and AEM water/Meth injection https://goo.gl/gpV5kW
    Reply With Quote  
     

  6. #6 Re: How to fix Regal dim HVAC 
    Turbo is the way to go. BillBoost37's Avatar
    Join Date
    Jul 2009
    Location
    W Spfld
    Posts
    26,833
    Thanks (Received)
    53
    Likes (Received)
    90
    Dislikes (Received)
    1
    FWIW, you can simply bring the console back a couple inches w/o removing it..

    The power port on the passenger side of the console though. I hated it so much I replaced it with some intrigue ones.
    I drink..so consider that when reading my posts.

    2010 Audi A6 Dual IC's
    Reply With Quote  
     

  7. #7 Re: How to fix Regal dim HVAC 
    GTP Level Member chevyy1212's Avatar
    Join Date
    Oct 2008
    Location
    IL
    Posts
    974
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    I ended up finding the 2 bolts after a hour of being dumb. As for the cigarette lighter I was trying to take out the one in the center not the one on the passenger side by the floor. Either way found the bolts and after 30 minutes of not getting the ciggarette lighter out i just pulled wiggled and got more than enough room without unhooking anything lighter wise to get the HVAC unit out. Actually really easy as soon as it all was realized
    1998 GS with Open cone, PLOG, ZZP Catless DP, tune & Intense MPS 3.6. Pulls good enough to make the woman smack me and call me a D!*k.
    Reply With Quote  
     

  8. #8 Re: How to fix Regal dim HVAC 
    Turbo is the way to go. BillBoost37's Avatar
    Join Date
    Jul 2009
    Location
    W Spfld
    Posts
    26,833
    Thanks (Received)
    53
    Likes (Received)
    90
    Dislikes (Received)
    1
    Glad it worked out. It's relatively easy once you get the bolts out.
    I drink..so consider that when reading my posts.

    2010 Audi A6 Dual IC's
    Reply With Quote  
     

  9. #9 Re: How to fix Regal dim HVAC 
    GTP Level Member chevyy1212's Avatar
    Join Date
    Oct 2008
    Location
    IL
    Posts
    974
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    It was actually harder figuring out which bolts for me. I swung it without taking the cigarette lighter out too wasnt to hard. I had my electronics department at my work
    re-heat those 5 and 3 others that pretty much fell off. Great writeup tho. Its so bright sweet
    1998 GS with Open cone, PLOG, ZZP Catless DP, tune & Intense MPS 3.6. Pulls good enough to make the woman smack me and call me a D!*k.
    Reply With Quote  
     

Similar Threads

  1. Will Dual HVAC Work in Stock HVAC
    By ljmonnin12 in forum General Tech Discussion
    Replies: 1
    Last Post: 11-25-2010, 10:57 PM
  2. HVAC Issue
    By mlasnoski in forum General Tech Discussion
    Replies: 1
    Last Post: 11-17-2010, 09:53 PM
  3. HVAC help
    By 3800SE in forum General Tech Discussion
    Replies: 15
    Last Post: 03-07-2010, 07:02 PM
  4. 04 hvac
    By Scott Francis in forum Introductions/Noob Questions
    Replies: 0
    Last Post: 10-16-2009, 03:36 PM
  5. HVAC Issues.
    By rynoman03 in forum General Tech Discussion
    Replies: 2
    Last Post: 06-08-2009, 03:17 AM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •