need help installing nitrous

**jordans gtp** · 01-04-2009

I have a 00 gtp mod's 3.5 pulley 2.5 downpipe coldair zzp replacement rockers and a very good tune the car run's 8.76 in the 8th i got a zex's nitrous kit for it dry shot had it put on and went to track it asks like it's in a bind i saw something about i need a thrasher nitrous installations kit if anyone can give me any feed back on this or how to install let me know

**SyntheticShield** · 01-04-2009

Moved to the correct area. It would have likely never been seen where you had it.

**Bio248** · 01-04-2009

you need a throttle body spacer.

TDCRacing · 01-04-2009

You may have a good tune now. But before you use the nitrous i'd add a lot of fuel via the MAF table untill you see how it will act.

Otherwise it WILL run lean and you may not have a car to go to the track with anymore.

Just a suggestion.

**blueguy** · 01-04-2009

Personally, ^^THAT is why I would never run the juice. I am down right afraid of it and would never install it based on the fact that it is unpredictable and you can go fast by doing other things..maybe not for the price, but I'll spend more money on an IC before N20

TDCRacing · 01-04-2009

Well it's not really unpredictable but it will make you lean out.

My 78mm tb made me lean out so bad my nb was showing double digits. Easily fixed with a maf and some extra fuel.

So would you not get a tb either? LOL just kidding man.

**UR LOSN** · 01-04-2009

nitrous is safe. I have it on all my drag cars... I mean street cars.

The thrasher TB spacer goes between the TB and the SC. it allows you to put the nozzle AFTER the MAF.... all you have to do is take the 3 10mm nuts off the TB that hold it to the SC. pull the TB off, install the longer studs that come with the kit... and slide the new gasket on then the spacer, then anothr gasket and TB.. and then simply screw the nozzle into the spacer.

I love nitrous.

when using a bolt up wet kit... you wont run lean if you use the proper jets.....