Cant seem to find one or any real info on it. Got any help guys
|
|
02-20-2012
Cant seem to find one or any real info on it. Got any help guys
02-20-2012
You'll probably have to lower the back of the subframe a little bit to get in there very good but a 18mm line wrench should be all you need.
02-20-2012
I can't remember which one is the pressure line, but when I did my rack I was able to reach down from the top of the motor and get the top line loose, and then once it was out of the way I went up from the bottom and got the other one. Lowering the subframe would have helped but I got it w/o doing that. If I did it over, I would lower the frame, lol...
02-20-2012
yea, the pressure line feeds into the bottom of the PS pump. You MAY be able to get to the rack side of the line without lowering the subframe, but I dunno, it's pretty tight!
02-20-2012
The pump side can be reached by removing the pass. tire and going through the wheelwell, I do remember that part for sure.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
