Thread: Yella Terra RR install ISSUE!

I installed my YT rollers last night; atleast in the front. We noticed the that back of the rockers were about 3/8 of an inch from the push rod. We even barley, and I mean barley, cranked the motor over a few times and the rocker would not touch the springs/valves. I done some searching and found on Intense's site and found this... I hope to help others if they run into the same problem as I thought I could use stock pushrods. Well you can use them, if they were modded 1.9's, but when you go YT RR's, you need the increased length. I can only find them at intense-racing unless I overlooked them on other websites. Stock length is 7.05" and the ones I apparently need are 7.30".

• PRL-705 - INTENSE Lightweight Pushrods, 5/16" x .049" X 7.050" set/12 (Stock Pushrod Length)
• PRO-705 - INTENSE Oil Restricted Pushrods, 5/16" x .083" X 7.050" set/12 (Stock Pushrod Length)
• PRO-730 - INTENSE Oil Restricted Pushrods, 5/16" x .083 x 7.300" set/12 (Yella Terra Pushrod Length)
• PRE-705 - INTENSE Extreme Duty Pushrods, 3/8" x .083" X 7.050" set/12 (Stock Pushrod Length)

This is why my stock pushrods were/are to short...I guess. Hope this helps, and her goes another $100.00 smacks!

take some pics of the pushrod install. do they just pull right out?

Yep, Yella Terra rockers come with pushrods for this reason when purchased new.

I bought them used. I only got the pushrods and petistels. Learned the hard way.

Pushrods come right out, just make sure they go back into the same hole that they originally came out of. Line them up to keep track of them.