What possible issues would cause the cruise control not to work? wipers, winshield washer fluid, blinkers, and brights all work off of that arm, but the cruise wont hold or accelerate. Thanks again, these forums are helping me out a lot.
|
|
07-15-2011
What possible issues would cause the cruise control not to work? wipers, winshield washer fluid, blinkers, and brights all work off of that arm, but the cruise wont hold or accelerate. Thanks again, these forums are helping me out a lot.
07-15-2011
having a burnt out bulb in the 3rd brake light will cause it to stop working
07-16-2011
one of the bulbs was burndt out, but that didnt fix the cruise. what should I look for to see of the cruise is hooked up by the throttle body?
Thanks again
07-16-2011
look at the TB see if both cables are clipped into it, my cruise control one used to unclip it self all the time.
07-16-2011
both cables are connected, one for the throttle and the other I presume is for the cruise, any other thoughts? I really appreciate the help/ideas
07-16-2011
Have you topped off your cruise control fluid?
07-16-2011
cant believe I didnt think of that, should I check the muffler bearings and blinker fluid also
07-16-2011
Don't think blinker fluid is the problem hereOriginally Posted by Cobras 98 Prix
cant believe I didnt think of that, should I check the muffler bearings and blinker fluid also
07-16-2011
check fuses. if good disconnect the single brake light switch on your brake pedal, (there is a double plug switch and a single plug switch) jumper the connector and and test drive. if the cruise works then u need a new switch, if it doesnt then u have another problem... (this is what was wrong with my cruise)
07-17-2011
where exactly would the brake light switch be located, up behind the pedal, and what do they look like, fuses were good
Thanks
07-19-2011
ok, disconnected the single connector and put a jumper with a paperclip, still
nothing, doesnt hold or accelerate. Any more suggestions
07-20-2011
sounds to me like its a bad switch. need to get a wiring diagram and start doing electrical checks
07-20-2011
would I be better off getting a new cruise control/blinker/ arm from a junkyard?
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
