|
|
11-10-2010
I changed my headlights the other day and I noticed that the driverside headlight sat higher than the passenger side (large gap between bumper and headlight assembly). I figured I would just try to fix it once I changed the bulb but when I put it back on the assembly still say higher than it should. Does anyone know why or how to fix it?
11-10-2010
I had the same problem when I just took my assembly out to inspect them.All I would say is to play with them a little,adjust and what not and eventully you should have even height assemblys.
11-10-2010
I messed with it for a loooooooooooooooong time and it wouldn't go in right, I got the passanger side in 5 different times but did not get the driver side onceOriginally Posted by dmahlikGT
11-11-2010
Thats funny because my driver side was higher too lol.And after closely inspecting it still isd slightly higher but not enough to notice.Try and get them as close as possible unless you're anal lol
11-12-2010
i got the same problem! so used some rings and put them between the car chassi and the screw and fixed my problem
Originally Posted by RedDawnGXP
11-14-2010
Whoa not to thread jack,but did you really get 15 flat with just an intake?how in the hell lol.
11-15-2010
oups it was a typo its 15.3 lol
Originally Posted by RedDawnGXP
11-15-2010
thats still pretty quick.You must launch real good.I put 15.7 stock and although I have an intake,180 thermo,and high flow cat I dont think im low 15 and im on sea level lol.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
