Intake questions 01 gt

[Rlugo87]

Hi there guys,
So this may seem like a dumb question but I guess I'd rather know them guess haha. So I am slowly modding my 01 GT not trying to make any serious numbers but just have a fun weekend car. I currently have a u bend delete, zzp pcm , autolite 104's, Taylor 8mm wires, zzp 1.9 rockers and hv3 insert the last 2 waiting for my 4th of July vacation to install. I guess onto my question, I have a home made intake and I'm wondering if this setup is doing more harm than good because of the 4in to 3in coupler and 3in intake tubing. Would I be better off getting a zzp 4in intake or making my own 4in intake or is what I have sufficient? The picture is kinda crap sorry I work nights and this is the only chance I had to snap a quick pic.

Sent from my Z958 using Tapatalk

[Rlugo87]

Btw I do have another piece of tubing to move the filter farther into the fenderwell or is that not going to be very beneficial? I know most of what I have done is maintenance the rockers and hv3 are the beginning of actual mods. Thank you guys.

Sent from my Z958 using Tapatalk

[Grimsin]

You can make your own 4" intake, but I went from a 3" to 4" and I didn't notice any difference.being a cold air intake or open air intake doesn't really make a difference except for real hot days sitting at a light then the open cone gets pretty hot, but once you start moving it's fine.
I say leave it as is unless your bored lol.

[Fivefingerdeathpunch]

104 plugs are way too cold for the mods, that's not helping anything there.

Autolite 606's are just fine the 170hp that motor is putting out.

[Rlugo87]

I have some 606's I can put in I got for my Bonneville. I guess I was just used to buying 104's because I am used to owning gtp's. Thank you guys.

Sent from my Z958 using Tapatalk