|
Steering rack and shaft showed up yesterday.
And motor unexpectedly showed up today at work ..would of been nice to be notified prior. Either way it's sitting in my garage now.
![]()
More na parts that will go in the trash, I've watched you guys thread.. I won't waste my time lol
Sent from my KYOCERA-C6745 using Tapatalk
Some of the bigger stuff might be posted eventually but I won't go overboard and some of the stuff I can use I'll use since its suppose to be a 15k motor but we'll see once I pull the vc
And yay Cali emissions cause I sure haven't seen a egr setup like this on a 3800
Sent from my KYOCERA-C6745 using Tapatalk
Yup considering the prices that l32/67 go for are ridiculous, its even crazier what ones with 125k+ go for, no thanks I'll stick with a low mileage l26 that hopefully wasn't beat on.
Sent from my KYOCERA-C6745 using Tapatalk
Because I want a bullet proof bottom end that will handle a lot more than I'm making, and the 383 is a bit heavier s a rotating assembly and it seems most performance camshafts I'm running into are all higher rpm, so if I ever decide to run a camshaft in the upper rpm range I don't want to have to build a new block up to do it.
-Apex Aaron
i added a degree of timing back to mine today, got the 3.0 and 16.5 timing wot. 1.3 blip of kr at the shift around 6,000 rpm. so i just took the timing back down a degree from 5800 up. see how it likes that tomorrow.
i dropped it a degree when i put the 3.0 back on to be safe. got the itch today lol
« Previous Thread | Next Thread » |