|
|
02-01-2015
I've been looking at methanol injection kits made by Snow Performance. they have three kits.
one that costs 360 stage 1 http://www.snowperformance.net/stage...st-cooler.html
one that costs 487 stage 2 http://www.snowperformance.net/stage...st-cooler.html
and stage 3 is 803 http://www.snowperformance.net/stage...st-cooler.html
for the kit to be as easy to use as possible after being set up, which one is the best choice?
02-01-2015
I went with basic cooling mist set up. No controller like the stage one kit. It works just fine for me, installed a low fluid light and activation light so I know when it kicks on. Might have got another 30 HP no where as good as NOS set up on my ws6 TA. I would get stage two kit if you were paranoid about blowing up your engine (I am not that concerned myself).
Djudge1970
02-01-2015
if your kr free with the small pulleys and ic why do meth?
02-01-2015
That thought just occurred to me Scott, sometimes I'm slow
02-01-2015
ALLLLLLLLLL of what scott said don't complicate the setup and your not going to gain a thing if your not knocking now it would be pointless.
02-01-2015
I will have to get the snout machined and then I will try the 2.6, do you guys think that is too much drop, or should I just go for the 2.55?
02-02-2015
Devils Own FTW
02-02-2015
this plus even with no KR, depending on where you're timing is at, add more timing LOL.Originally Posted by danomite02
02-02-2015
you can only run so much timing advance
02-02-2015
understandable, thats why it depends on where you're currently at. if only at 16* with the meth and tune, can add a few more degrees
edit-for example i ran 22-24* with a 3.2"/3.3" and when turbo i ran 20psi with 20* of timing
Last edited by fst; 02-02-2015 at 10:49 AM.
02-03-2015
That is too much timing.
02-03-2015
No it's not. I ran 24* with good results.
Of course, I bypassed that diluted junk and went with 100% methanol and a DO-10 nozzle.
02-03-2015
That much timing is hard on head gaskets. You are picking up very little power with that much anyways.
02-03-2015
i think there were debate on how high of timing was considered wasteful. back on CGP someone was able to run as much as 30+ degrees and the motor held up fine but the power was not making anything above 25-26*. i ran 25* on 3.6" to 3.4" on my current motor for a long while and headgaskets are stock and going strong (~200k mikes). reptile, im running 70/30 meth/water on m5 or m6 nozzle.
02-03-2015
I'm going to do another pulley drop, trying to decide between 2.6 or 2.55. I can the 2.6 that reptile has for a good price, but I would probably have to get the 2.55 new.
02-03-2015
i think the difference going from a 2.6 to 2.55 is negligible (parasitic loss). at that small a pulley add timing ;-p
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
