Ford Probe Heater Core??

Quote:

---

Originally Posted by BillBoost37

The rubber isn't all it's cracked up to be. I tested this out when it was being looked at etc.

---

what did you use it on phenolic or aluminum? What problems did you run into. did you use the same thickness?

I just found it weird that the 1-5/8 core is the right one, but I guess it is.

Quote:

---

Originally Posted by BOOGIEMAN

what did you use it on phenolic or aluminum? What problems did you run into. did you use the same thickness?

---

Aluminum. Same core pictured in the last post of the previous page. It gets dirty etc and doesn't seal as good as good old paper and rtv. It's easy to tighten bolts and have it bunch etc. I like to torque the SC down to it's ~17ft lbs

http://pages.ebay.com/link/?nav=item...d=371126788448
should work then for a gen5 zzp FSIC ?

Quote:

---

Originally Posted by crazyguy03

http://pages.ebay.com/link/?nav=item...d=371126788448
should work then for a gen5 zzp FSIC ?

---

Should be the same core for both. only difference is the opening of the ic is bigger on gen v.

Thanks. Better to ask then guess