|
|
10-17-2014
Hey guys lately ive been fighting with my car to get it back up and running. I did a full rebuild to the engine and ever since i put it back it has been giving me this code p0102. I replaced my mass air flow sensor which was $220 and hoped that was it but nope it wasn't were else should i look?
10-17-2014
The wire harness going to it and likely damaged or faulty.
10-17-2014
check the fuse box for a blown fuse, 24 or something like that. also bad wires to the maf can cause the low Circuit code
10-18-2014
Ok ill do that tomorrow morning thanks
10-18-2014
How could it be damaged? Like a bad connection or something?Originally Posted by Fivefingerdeathpunch
10-18-2014
thos wires bake in the heat of the crossover pipe, insulation can fall off or have cracks. <<<this will cause a code.
10-18-2014
I know what its is then ive got headers and they produce a lot of heat so that must be it
10-18-2014
mine were shot to hell stock. wires had dry wire 2 inches from the main harness. both my maf and ait sensors pig tails were toast.
10-19-2014
Hey its my fuse but it keeps going out. Where should i look
10-19-2014
I got it to work once and then it went out. Now as soon as i turn the key on it goes out
10-19-2014
check the o2 sensor wires and the maf wires.
or if you have a open cone filter and the pcm laying on the frame, look for a rubbed wire to the pcm.
10-19-2014
Ok i will when i first changed it it was fine and i went for a drive for the first time since ive had it in the garage so that was like over a year ago and it ran like hell hit about 55 on 1st gear then 100 on second and now everytime i turn the key on it blows the fuse. This is the last thing i need to figure out so i can finally bring it out agian! Im so excited ha. Ive checked the maf wires they are fine idk about the o2 ones.
10-19-2014
How come i ran fine the first time tho?
And i do have the cone filter and pcm on the frame
10-19-2014
when the fuse keeps blowing its mostly due to a bad wire somewhere.
10-19-2014
Ok then i hate these ones haha just because sometimes it takes for ever to find it but at least i know what it is. Before i was all over the place trying other things but now i now what it is
10-19-2014
Found it!! So some idiot before me did this!
It was hitting the headers
10-19-2014
Man that makes me cringe. Solder and heatshrink is my preferred method.
10-19-2014
nice lol.
you want to cut them apart, strip the wires back on both sides till you get clean shinny copper, then solder and shrink tube them back together.
10-19-2014
Yup doing it in a bit. Man my car has been sitting the last 3 month because of this crap. I did everything you could possibly think of until i joined this forum and you guys help me track it down to this. Thanks to everyone that helped.
10-19-2014
should have came here sooner. we see stuff like this a lot. pretty common if the fuse keeps blowing.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
