OK I went to advance this morning and picked up two outer tie rod ends and a front wheel bearing. Tie rod was a piece of cake. Had to go back to get a 35mm deep well for the drivers side axle nut. For the life of me it will not budge. I've soaked it in nut blaster. I have about a 2' breaker bar on it. Beat the hell out of it with the rubber mallet. Even stood on the end of the breaker bar. I'm thinking it has red loctite on it as the nut blaster is tinted red after a few sprays. Any suggestions? I'm thinking I may have to take this one to the mechanic with his impact wrench. Thanks!
Sent from my DROID RAZR using Tapatalk
