Thread: What did you do to your Car today?

Well it turns out my old wb must have been getting lazy or something or my tune is out of wack now but my afr is pegged at 10 at anything more than 3/4 throttle. Looks like I'll be tuning some tomorrow.

I think a Ford Edge tried to race me earlier tonight....then I think he stopped trying when he heard the supercharger whine.

Originally Posted by Taz238

I removed the stock air filter and box and put a cone filter on the end of my throttle body I didnt hook back up that sensor so my check engine light came on is this a bad thing

Taz238

what year is your car. if its a 97-03 just drill a whole on a couple and plug the iat sensor in

Originally Posted by Taz238

Its an 02 gtp



Taz238

get a 3inch coupler in the plumbing dept in home depot drill a whole in it plug the sensor in and your done get the code cleared and be done

That sensor usually has an affect on fuel trims. What he mentioned was to get a pipe to put in between the TB and the filter so that you can install the sensor.

Finally got a chance to throw in and program my ZZP PCM. Couldn't program it before since my BCM was bad. All is good now!

Originally Posted by Taz238

There is nothing to screw into. The filter is strapped to the tb

Taz238

I would space it off the TB a bit. Having your intake directly over your exhaust crossover ain't exactly a good spot due to the heat.

anyone know what is the difference between wbody store tb adapter and zzp one for genv swap?

Originally Posted by 02NavyBlue

Quarter is 200°F, no need to go past that. If it bounces once or twice when warming up that's pretty much normal.

Mine always ran at half way, does that mean something's wrong?




Also haven't really done much with the lack of time and **** load of snow I've been getting. Also still need to get the tranny looked at, the fluid is still red after a nice 4hour drive so I don't think it's a major problem but It's still making me paranoid .. Also I think I might need to change a rear hub

Sent from my iPhone

Picked up my new Air/Fuel set up to replace the one that broke, and while I was out picked up some carbon fiber vinyl to do some work on my motegi traklite rims. Going to use it on the center caps to black it out even more. May find some other use for it to, will have to wait and see.

I have been going back and forth on lowering my GTP. After seeing it photoshopped lower I like the look.

That roll of carbon fiber look expensive... ebay my duu

Originally Posted by Nates94

I have been going back and forth on lowering my GTP. After seeing it photoshopped lower I like the look.

I'm the same way. Every time I see a really nice lowered one I want to do it.