https://uploads.tapatalk-cdn.com/201...710ad9de8d.png
Sent from my iPhone using Tapatalk
Printable View
https://uploads.tapatalk-cdn.com/201...710ad9de8d.png
Sent from my iPhone using Tapatalk
This is the kit I bought from AutoZone
Sent from my iPhone using Tapatalk
FWIW here's pics from me doing the Bonneville ones
http://i20.photobucket.com/albums/b2...n/IMG_3717.jpg
Overall.. I had to pry them a bit, think I air chiseled a little as well for the super rusty crusty. Overall, took maybe 2 hours total, being super careful with two stands holding the car and two holding either front or back of subframe where I was working. Can't be too careful under there. Jack stands are cheap
https://uploads.tapatalk-cdn.com/201...91a8c88167.jpg
Sent from my iPhone using Tapatalk
What is the order of assembly?
Sent from my iPhone using Tapatalk
I installed new trailing arms, sway bar and end links. But now the right side makes a creaky sound when climbing or descending a curb. Everything is super tight and torqued to spec.
Sent from my iPhone using Tapatalk
spray down the sway bar bushing with lube to see if the noise goes away.
Silicon spray? Remove bushing, spray and reassemble?
Sent from my iPhone using Tapatalk
any lube like wd 40 or similar is fine. no need to take them off just spray well into the seam and around the bushing. Drive it around the block a couple times and see if the noise goes away or lessens. If the noise goes away or lessens then take the bushings off and grease them.
Ah. Great idea. Thanks
Sent from my iPhone using Tapatalk
if it stops after spraying it, its gonna start again one day soon. so you can then take the cap off and the bushing, then wrap the bar with teflon tape, or grease it and put the bushing and cap back on.
Applied teflon to rear sway bar. So far no more squeak.
Sent from my iPhone using Tapatalk
I had serviced transmission awhile back and torqued nuts according to specs. Noticed transmission fluid around base of pan. Do I need to re-tighten or replace gasket??
Sent from my iPhone using Tapatalk
did you not reuse the stock pan gasket? if you didnt, thats the problem.
I installed a new one
Sent from my iPhone using Tapatalk
It was just like the other one. Neoprene with steel insert
Sent from my iPhone using Tapatalk
Did this back in March
Sent from my iPhone using Tapatalk
spray it all down with brake cleaner and keep an eye on it, could be a axle seal leaking and running down.
or maybe its motor oil? my old engine leaked so bad the tranny pan got coated.
Would it hurt to snug up?
Sent from my iPhone using Tapatalk
Can't see any transmission fluid leaking from axle seal.