Phenolic Intercooler for your Gen3/Gen5 M90, L67/L32 3800's - LOOK INSIDE

Quote:

---

Originally Posted by sseilmnop

Gen 3 intercooler w/bolts and shipping $519(total price)
Gen 5 intercooler w/bolts and shipping $525(total price)
Machined Manifold $90 plus $50 core charge (shipping included w/ intercooler purchase)
Shipping, USPS (lower 48 states)
Canada add $25 for shipping

---

Quote:

---

Originally Posted by Classy Pontiac

Pm me the price of the intercooler, may be interested. Thanks

---

........

Still selling.
Have 2 ready to ship.

Do you have any pulley pullers left? How much?

I have 5 pulley pullers ready to go. Current price $84 including flat rate shipping to USA.

Will they install and remove modular systems hubs?

Remove stock pulleys and install modular hubs. Removal of modular hub requires the pulley to be bolted on.

PM'd you

Thinking of doing a Gen V swap on my 02. Does anyone know if this will clear a stock hood with a gen V swap???? I am going to get one either way but came across a gen V and LIM for 100 bucks!!! Insane so was thinking of swapping it on.

Yes it will clear. I had engine and trans spacers that raised motor up half an inch and the top of the vac t thingy just hit my hood, without the spacers it would've cleared just fine

Received puller today.....everything looks good,can't wait to install the hub

The puller worked perfectly,removed stock pulley and and installed hub with ease....with just two crescent wrenches big enough for the bolt and nut

You wouldn't happen to rent out the pulley pullers would you?

Quote:

---

Originally Posted by Jomamma

You wouldn't happen to rent out the pulley pullers would you?

---

Sorry no.

I have 2 Intercoolers and 1 machined manifold ready to go. Pricing is on the first page first post of this thread.

might of missed it but how much does your supercharger pulley remover run?

$86 including shipping USPS flat rate.

2 more intercoolers on the way. I currently don't have a machined manifold.

these dont require any special tuning, correct?

You can run without a tune. You will want a smaller pulley to push more boost. A tune will make more power.

Current price is in first post which is $549. My material cost has gone up $40. Yes you can send your manifold in for machining.