Thread: Has anyone used the PAC RP5 GM11 adapter harness?

Originally Posted by chrsmi1

Yellow i believe is constant hot. Not sure how it would be my error as it was grounded good, and the yellow wasn't spliced or anything by me. It was just a plug and play thing on that side of it. Pretty sure it was just a bad part. I'm going to call the manufacturer tomorrow and see what the deal is.

Sent from my SAMSUNG-SM-G920A using Tapatalk

by install error I meant like it rubbed through the insulation on the blue enclosure.

did you get another one or what did you end up doing?

as far as connecting it directly, Chrias I think your going to have issues.

Originally Posted by J57ltr

by install error I meant like it rubbed through the insulation on the blue enclosure.

did you get another one or what did you end up doing?

as far as connecting it directly, Chrias I think your going to have issues.

Oh I meant to post an update. Sorry. I contacted their support and after a little runaround they sent me another module. I haven't installed it yet so nothing to report as far as it being ok or not.

They did recommend that I have it professionally installed just to rule out any such issues being me, but I informed them that unless they were sending me a check to pay for that, I'll be installing it myself again.

They did say they might have their engineering dept contact me about sending the defective unit back so they could go through it. Haven't heard from them about that yet though.

Sent from my SAMSUNG-SM-G920A using Tapatalk