HID"s in Stock Headlight Assembly

[wyrmscar]

I currently have projectors and the adjustment screw for up and down, is well non existent(broke). Im am basically tired of projectors and am considering of going back to stock headlights. So i currently have h3 8000k's and a 2001 4 door gtp. just putting it out there. How would i do so? i seen people on here doing it but im confused of what would have to be done seeing as the stock headlights dont have seperate sockets for high/low beams... Appreciate the input.

[z3r0]

You get the.right hid.bulb and jam it in the hole

[tc300]

I run hids in my stock housings.... VERY pleased with them.

And FYI there not as bright as some of the ppl say when talking about the "glare".

[tc300]

Also I just run a single low beam....

[wyrmscar]

Well i figured that much, but what would i do about the high beam bulbs?

[Josh Ehlert]

The high an low beam should be one bulb assuming you buy an hid kit that has high an low beam.

[Bologna]

^ Correct, at least that is the case with a 97 gtp

[Odi]

dont get bixenon, they dont project light properly in our housings.

[wyrmscar]

The high an low beam should be one bulb assuming you buy an hid kit that has high an low beam.

UGHHHH... that sadly is exactly what i dont want to do.. the current kit in I have is only 3 months old.

[wyrmscar]

dont get bixenon, they dont project light properly in our housings.

This goes against what josh just said... and honestly if it came to having bi xenon, i would just say screw it and keep my retarded projectors.

[wyrmscar]

As you may see... since the adjustment screw for up and down is f**ked, the only way i can actually get use of my hid's is to have them look ghetto as seen by the bottom pics. Otherwise the grass on the side of the road looks really pretty but the road is not -___-