old video, finally uploaded tho
https://www.youtube.com/watch?v=ZZIL...p;feature=plcp
Printable View
old video, finally uploaded tho
https://www.youtube.com/watch?v=ZZIL...p;feature=plcp
Nice nice man. How did you get it so loud with trunk open? Mine sounds hollow with the trunk open, still loud but like without compressionQuote:
Originally Posted by 1LoudGrandPrix
bet yours isn't sealed off, or near as well as mine
I have the Polk Audio db212-2. It's a ported box.
Not my car but it's the box that I have. http://img.tapatalk.com/425791e4-a0f0-b4cb.jpg
http://desmond.imageshack.us/Himg191...pg&res=landing
Just a new deck nothing too fancy. But it's the first one I put in.
curent re audio se 12's, re audio dts 1500.1, stock nav
http://i442.photobucket.com/albums/q...8/CIMG1939.jpghttp://i442.photobucket.com/albums/q...8/CIMG1936.jpghttp://i442.photobucket.com/albums/q...s/IMG_7977.jpg
I've just finished putting a Pioneer AVH-P2400BT in. I had a XM receiver from my previous ride, and added HD radio to it. (If I'd done just a little more homework, I would have gotten the next level Pioneer that would have had the HD radio built it.) It all pours into the OEM Monsoon amp system.
I've got the Bluetooth mic sitting under the instrument cluster temporarily. I can't make up my mind whether to mount it in the overhead lamp or hack into the On-Star and use its mic.
I'm also looking into getting an XM antenna off a later G6...which mounts on the trunk lid...so that I don't have to worry about the magnetic base of the Pioneer antenna sliding all over the place.
I've got two problems I still need to clear up. I'm getting RAP feedback into the engine's run circuitry. The engine will run with the key off until I open the door. I'm thinking that the GM-01 adapter I got, which has a hookup for the VSS and backup circuits might be back feeding the PCM through the VSS circuit. Since I'm really not planning on GPS for this, the next time I pull the radio, I've gotta hack into that nicely wrapped harness and cut that.
The other issue is some very occasional popping and scratching through the Monsoon amp that I'll hear with the volume of the head unit turned all the way down. I'm going to give ground loop isolators a whirl...but I'm not real hopeful. I've swapped amps and still have the problem, though one amp is a bit better than the other.
2 18s on 12k
http://www.youtube.com/watch?v=B2rcILiR9tI
hairtricks lol i can lift dreads in my back seat on 12's lol
Im currently still upgrading my system little by little so thats my only project in progress, not sure if these specs was necessary but i posted them anyway.
http://s17.postimage.org/b4d42zqmn/2...740_Custom.jpghttp://s17.postimage.org/6wibu8p73/2...307_Custom.jpghttp://s17.postimage.org/w3t7uhsb3/2...344_Custom.jpghttp://s17.postimage.org/ksqk64lfz/2...357_Custom.jpghttp://s17.postimage.org/5y1yrybv3/2...415_Custom.jpghttp://s17.postimage.org/4kabwnclr/2...436_Custom.jpg
AMP:
- 1 Ohm Stable Class D Mono Block Amplifier
- Low Level Input and Output
- Frequency Response: 15Hz ~ 270Hz
- Input Level: 6V~0.2V
- Variable Subsonic: 10Hz ~ 50Hz
- Variable Low Pass Filter: 35Hz ~ 250Hz
- Variable Bass Boost: 0db ~ 9db
- S/N Ratio: >85
- THD: 0.1%
- Remote Gain Controller
- Two Amplifiers Linkable Connector and Selector
- Fuse Rating: 60Amps, Linked Fuse Rating: 120 Amps
- 1500 Watts Max
- 800 Watts RMS
- Dimensions (Inches)
- Height: 2.18
- Width: 9.13
- Length: 11.81
SUBS:
- RMS 400W
- MAX 600W
- Impedence (Ohm) 2x4
- Rdc (Ohm) 1.7
- Levc mH 1.346
- Fo Hz 36.2
- Sd msqM 47.14
- BL TM 8.624
- Qms 3.617
- Qes 0.786
- Qts 0.645
- n% 0.222
- SPL dB 87.5
- Vas L 37.1
- Cms uM/N 111.1
- Mms g 164.8
- VC Inch 2
- Mgnt oz 80
- Xmax ±MM 11
- F.Range Hz <800
- MM 150
- Inch 5.9
- SPK DISP. L 3.583
New to forum hope to post pics soon Once I figure out how but I have a kenwood ddx419 alpine type-r 6 1/2 components all around with custom pods for rear. Two type- r 12 dvc 2 ohm subs ported box. Fosgate amps 400.4 & 800.2. Just purchased additional 800.2 along with 5 farad capacitor which I havent installed yet.
Nice job BFF Larry!!! What 18''s?!?! I'm going to forget the "all in the trunk" single sub setup and trade-in my SMD for 2 18''s or 4 15''s!!! What subs are you running?!?
I cut out the 6'' port and doing an 8''... lil better numbers....
https://sphotos-a.xx.fbcdn.net/hphot...32901727_n.jpg
how do you post pics
Do not use a Cap!!! It is easy to put a HO DR44 alt on! They usually ate on Tahoes and are very common and easily do 300a
Check my sig or my other thread here on HO alt in a Grand Prix
Sent from my Galaxy
Attachment 9974Attachment 9973Attachment 9975Still a work in progress hope to get it finished this winter
How did you make the Grand Prix GT thing light up? I like that!
The light up "GP GT" radio mount is from Humount. Here is the link Grand Prix 1992-2003 - $65.00 : Humount, Quality Mounting BracketsQuote:
Originally Posted by stuntsiderida100
For some reason I can't post my pics off my phone. Will have to later. Currently have my prix set up for 2 18s walled in the back seat off 2 shok industries 5kws. I will be running team shok 18s this next spring. Ill figure out how to post some pics up as soon as I get home. I have a build log if you hunt through my started threads though until then.
your gonna have to use photobucket or an alike website to post pics here, cant wait to seeQuote:
Originally Posted by maverickdog8