Thread: Grill Lights write ups anyone?

Anybody got a write up for installing 2 grill lights such as these:

Whelen Engineering - Lightheads - Lightheads, Directional Strobe, Super-LED

hopefully your write up includes wiring it to the fuse box, i think that'd just be the safest for me to do in terms of draining the battery. Also i hope you have an idea for a manual switch on the inside of the car so the lights dont just turn on with the car in aux or ignition.

Thanks

i like the fog light idea, but mine are switched on all the time, they have some kinda sensor in them that they only turn on in like cloudy, rainy ish kinda days. i dunno how to describe it but the switch is always in the on position but the lights are not always illuminated

i suppose its possible to just go around the sensor, but i have no idea where itd be located, anyone?

yea but the point is they cant be on while the car is in motion, and i plan to use them as courtesy lights for responding to EMS calls from home

rather they have to be able to go on and off in motion

Hope this helps

lol any idea how to pop off the dashboard so i can run the wires behind it?

Also what size gauge wire do you think would be necessary for these kinda lights?

Originally Posted by EJRJR91

lol any idea how to pop off the dashboard so i can run the wires behind it?

I took the plastic piece off in the foot well and ran them to the center console. and if you want to place them/route them in a certain spot you could go to target or such a place with 3M products and look for some plastic hooks that have the sticky backs to them.

Originally Posted by EJRJR91

Also what size gauge wire do you think would be necessary for these kinda lights?

It depends on how many LED's you are planning to run. In the tech specs for the product it should say how many leds and some say how much power each led takes to power it (doesnt take much). Depending on how much power you need is going to depend on the gauge but you wont need too little of a gauge considering LED's take up nearly no power at all

so what would u say is the smallest u could imagine me needing? just so i have like a limit to size

Originally Posted by EJRJR91

so what would u say is the smallest u could imagine me needing? just so i have like a limit to size

how many led's and what is the current needed to power each individual one?

not sure what the current needed is but i'm planning to have two leds, of the ones in the link above

LED's use almost zero power.

so i guess any gauge would really work then

I'd go with a ten amp fuse max with 16 gauge wire

cause if they are LEDs like mine. They use 12 milliamps which is like one hundreth of an amp

what kinda LEDs do u have? show a pic if thats easier