|
|
08-26-2013
So I've been prepping myself to tackle this camshaft and gasket overhaul for my engine, and I am positive I have everything, except for a smaller supercharger pulley. I don't plan on driving hard core until I get a tune and I just wanted to know which size pulley I should go with based on a VS cam, SD Headers build? I was thinking 3.4, but I'm not sure. Any ideas?
08-26-2013
Stock 3.8 until your scanning and tuning
08-26-2013
So when I am scanning and tuning, what should I jump to?
08-26-2013
Will depend on scans & tuning results... I would think a 3.25 might be in your future but a 3.4 would be a solid start
08-26-2013
Is there any harm to running the 3.4 when daily driving (not in boost)? Also, is it worth the extra 150 to get wideband support for the hptuners interface
Sent from my SCH-R530U using Tapatalk 4
08-26-2013
3.4 would be my guess and yea DD will be fine as long as the tune is up to par and your not knocking you'll be fine.
08-26-2013
3.4 it is! Thanks guys
Sent from my SCH-R530U using Tapatalk 4
08-26-2013
Same setup as you except a gen v with me, I have a 3.4 on it for a dd you can drive it but stay off boost or take off the belt till you get a to tune it
| « Previous Thread | Next Thread » |
