|
|
10-10-2012
Ok so after i changed to open cone intake my cooling fans stay on all the time so my engine never heats up much at all.
Im guessing its either because 1: My pcm is broken cause its just sitting there under the 9" Spectre cone on the bottom of where old intake used to be, or 2: Because the sensor that was in the old intake is ziptied in the engine bay and not inside the tubing from the intake to the throttle body.
Which do you think.
10-10-2012
Obvious answer. Clearly you need to drill a hole and put it where it belongs.. not sure if that has anything to do with your fans though.
Sent from my SPH-L710 using Tapatalk 2
10-10-2012
Then it's not obvious.
10-10-2012
prob broke the wire that goes to the temp sensor does ur temp gauge move at all?
10-10-2012
it usually stays really low. like 1-3 notches above 160. but it does move up to that.
10-10-2012
Actually with the possibility of it being the thermostat im going to wait til i do the lim replacement and see if it continues.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
