Thread: Safe to drop pulley size?

Intake
Car tuned up
3" downpipe
Plog
Ported gen III
Dhp 1.0 pcm or something similar?

You might be able to run a 3.4 I would get a scanner though just to check for kr.

scan first.

possibly could run a 3.6.

I've seen others run a 3.4 with those mods, but every car is different. Just get a MPS and try different pulleys, pulleys are cheep, start big and work your way down.

scan before ANY pulley drop

Is there much difference between stock vs 3.6 vs 3.4?

if your going to buy a plog and downpipe, why not just buy headers?

Originally Posted by Elite6

Is there much difference between stock vs 3.6 vs 3.4?

Yes.

Just get headers.

And i hate your avatar.

Originally Posted by BlackGT97

if your going to buy a plog and downpipe, why not just buy headers?

Already got a dp and am looking for cheap plog for now. Eventual plan is headers and gen v but not right now.

Then plan on not dropping pulleys either.

Originally Posted by Nixon

And i hate your avatar.

Pretty insane pic. Kinda creeps me out.

LOL.

Originally Posted by Nixon

Then plan on not dropping pulleys either.

No pulley drop on dp and 3"?

Scan first.

But i guarantee you'll be faster running more timing on a stock pulley than struggling to run a 3.5 or 3.6

Originally Posted by Nixon

Scan first.

But i guarantee you'll be faster running more timing on a stock pulley than struggling to run a 3.5 or 3.6

But headers will cure all that? With headers could i go lower than 3.4?

No.

Headers and a cam you could go below a 3.4

headers, rockers and intercooler....ready go

Just get the headers man...I just finished installing mine a hour ago and the top end is way more awesome even with my stock 3.8 pulley

With just headers on my other wise stock car I dropped 4 seconds off my 0-100 times