Thread: 1.9 Terra Roller Rockers and Pushrod angle...

Results 1 to 4 of 4
  1. #1 1.9 Terra Roller Rockers and Pushrod angle... 
    SE Level Member
    Join Date
    May 2012
    Location
    Fargo, North Dakota
    Posts
    11
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    ...will I have an issue with this? And if so, is there a fix?

    Thanks for reading...
    Reply With Quote  
     

  2. #2 Re: 1.9 Terra Roller Rockers and Pushrod angle... 
    Turbo is the way to go. BillBoost37's Avatar
    Join Date
    Jul 2009
    Location
    W Spfld
    Posts
    26,815
    Thanks (Received)
    53
    Likes (Received)
    90
    Dislikes (Received)
    1
    Not sure what the issue is. Didn't yella's come with pushrods that were the correct length?
    I drink..so consider that when reading my posts.

    2010 Audi A6 Dual IC's
    Reply With Quote  
     

  3. #3 Re: 1.9 Terra Roller Rockers and Pushrod angle... 
    GXP Level Member darkhorizon's Avatar
    Join Date
    Feb 2009
    Location
    flintnasty MI
    Posts
    2,596
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    angle as in they are really close to the heads...

    The YT rockers are probably going to be a bit better than modded stock... but I would check them on a L32 motor.
    Reply With Quote  
     

  4. #4 Re: 1.9 Terra Roller Rockers and Pushrod angle... 
    SE Level Member
    Join Date
    Oct 2009
    Location
    Melbourne
    Posts
    6
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Hi Guys,

    The pushrod is quite close, obviuosly due to the higher ratio. Make sure you check clearance especially with the GM castings. Weve seen many castings have cast flashing that needs to be filed back in some cases. Also Im assuming they are unmodified factory heads. Just check if they have been milled or not also /.
    Reply With Quote  
     

Similar Threads

  1. 1.9 terra yella roller rockers
    By nascartech in forum 3.8L V6 Naturally Aspirated (L36)(L26)
    Replies: 15
    Last Post: 01-19-2010, 11:17 AM
  2. Pushrod length with ProMagnum rockers?
    By Infinity9999 in forum General Tech Discussion
    Replies: 3
    Last Post: 09-08-2009, 05:13 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •