Thread: 1.9 Terra Roller Rockers and Pushrod angle...

...will I have an issue with this? And if so, is there a fix?

Thanks for reading...

angle as in they are really close to the heads...

The YT rockers are probably going to be a bit better than modded stock... but I would check them on a L32 motor.

Hi Guys,

The pushrod is quite close, obviuosly due to the higher ratio. Make sure you check clearance especially with the GM castings. Weve seen many castings have cast flashing that needs to be filed back in some cases. Also Im assuming they are unmodified factory heads. Just check if they have been milled or not also /.