Thread: GenV Supercharger Pulley removal

Im trying to install an mps by smoothflow on my GenV supercharger , th instructions say to remove bolt from pulley and then use the pulley puller(purchased) only problem im having is that there is no bolt where I could put my wrench into any help will be appreciated thanks.

should be a plastic "christmas tree" esque fastener then.

Originally Posted by matt5112

should be a plastic "christmas tree" esque fastener then.

Ok so how do I remove the fastener?

the pulley is the one on top not the bottom one .

yes, and a quick tip: that plastic piece will unscrew counter-clockwise. i wasted so much time trying to rip it out like a caveman. just unscrew it. then follow the instructions with the puller kit and its generally a piece of cake. make sure you put that modular piece on correctly, you only get one shot at it.

Originally Posted by gloebird

yes, and a quick tip: that plastic piece will unscrew counter-clockwise. i wasted so much time trying to rip it out like a caveman. just unscrew it. then follow the instructions with the puller kit and its generally a piece of cake. make sure you put that modular piece on correctly, you only get one shot at it.

Thanks gloebird! ill use some penetrating spray to soak the plastic piece its super tight.