Hey I was just wondering what kind of AFR are you all running on your GTP?
|
11-11.3
Iz too rich since i'm intercooled.
0...
12.5. I'm gonna add some fuel, add some timing and drop a few pulley sizes when I get a chance to not be lazy and go tune it. Maybe aim for around 11.5. We'll see.
11.5ish is where you want for a non intercooled car. Intercooled car 12ish.
11.9-12.2 is usually where im at
I was running 11.2 until today and lower 10's before that. I changed it to 11.5 today. What happens if you run too rich like I did? I only noticed it bogged me down at the end of the track.
If you get to rich that can actually cause knock. You run the risk of White washing the cylinder walls(really rich)m and diminished performance(boging like you experienced). If your gauging your AFR off of Commanded AFR that is NOT accurate one bit. You need to be looking at a wideband
You mean without the guage? You can't just buy the sensor itself, needs a controller or power.
I'd rather have a wideband with a guage for a couple reasons:
1. To get the correct AFR setup for scanning, with the guage there you can double check to make sure the formula you entered for PID is correct, sometimes the formula may need adjusting and you don't realize your actually at a 11.2 AFR when the scan says your at a 11.9 AFR...
2. When you're not scanning it is a great tool to be looking at or to have. You could save an engine or find an issue before it starts to get worse.
wanna get technical, for the normal car 14.7 to one is the best lol
« Previous Thread | Next Thread » |
Tags for this Thread |