Quote Originally Posted by matt5112 View Post
Inlet is just to smooth it out with the TB right?

when porting the TB, DO NOT TOUCH the area where the blade touches the walls of the TB. Clean it up a little with some degreaser but thats about it. (carbon build up causes sticky throttle)

When you go to port your TB you'll find that you might make a small hole near the front. Just put some epoxy on the outside to keep it sealed. You can open it up quite a bit, but you can't make it perfectly round. Try searching on here for some more pics.
this is correct. do not make the blower inlet any bigger than the throttle body or youll be wasting a lot of time and effort for nothing.