Double check all the wiring. Use a multimeter set to ohms and grounding to try and find the issue.
|
|
08-15-2011
Double check all the wiring. Use a multimeter set to ohms and grounding to try and find the issue.
08-16-2011
I will do that. Is it possible to have gotten bad solenoids? Also, billboost, that link isn't working that had the info about the ohm tolerences. Could repost that link, please. Thanks again.
08-20-2011
Ok. I went and got a multimeter. Ok, from what I'm getting is that I check resistance from tcc fuse and at the pcm connector. Do I unplug the pcm or leave it plugged in? And what pins do I check?
08-27-2011
Ok. Wiring all checks out. I'm thinking now it the ecm. Is that uncommon for the ecm to go bad and cause it to blow the tcc fuse?
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
